-
Forum Statistics
8,144
Total Topics274,388
Total Posts -
Member Statistics
-
Who's Online 2 Members, 0 Anonymous, 58 Guests (See full list)
-
Topics
-
Posts
-
Thanks so much for replying Dean, yeah I was gonna give that a crack in the morning & did think wether undoing the top nut & bottom bolts then lowering the jack may work. Hopefully the springs aren't shagged, oh well to bad I'll give that ago & see how I get on.
-
if it's an XE or XF with coil springs on the diff, you should be able to with the car on chassis stands/hoist..just undo the shocks and lower the diff down with a jack so the springs basically fall out of the way.. remove the spring and shock(air) as one and then refit the others any way you like
i've never removed the boot hump things, but there might be enough clearance, worth a try if you can't do the chassis stands way. only 4 bolts and you'll soon find out. -
Hey Guy's. Awesome Andy's amateur mechanical hour strikes again.. Was happy day's removing shock absorbers untill bearing in mind the one's I'm removing are Air shocks with a larger diameter circumference on the upper shock not allowing it to slide out. What's next do I drop the diff & remove the whole spring 🤔 The little 10mm bolt on a sway bar coming out either side of the diff,is that what I remove? Really don't want to have to do that. Can I remove the top shock cover in the boot & pull out from above, oh god that's getting real amateur hour now. Any tips cuzzie bro's from across the ditch 👀🤣 Cheers 🍻 💥
-
Hey Bear, thanks alot. I've gone ahead & bought KYB Xcel G shocks, hopefully they go in with my current springs which i think are just lows not superlows. I did jack it up a little bit & measured the spring which was 25cm from the top to where it sits at the base, give or take a couple centimeters. Also measured bottom of the outer sill to the floor was 12cm. Few of the guys on XF FANATICS have gone with KYB on low shocks, finger's crossed 🤞I'm not on super lows, most of the modifications on my car are about 30yrs old now hence there being air shocks which apparently are a thing of the past haha 😄. It's gonna suck if they shocks don't fit 🥴🧐😅
-
Hi mate, probably the rubber 'bag' which is inside the shocks. (they crack/wear etc) could try to source an Air Jackers kit, which used to contain the Schrader valve, coupling, tees and couple of metres of black flex line. Not sure if you buy 'em on eBay or whatever? If you have lowered suspension, you'll need lowered shocks, or they will bottom out, and fail prematurely. Monroe is OK, Pedders have a heavy duty set with bigger bore and thicker rods. If you're cashed up, go Koni or Billsteins.
-
By SPArKy_Dave · Posted
Did you unbolt the steering column, to remove the cluster? To me, it's all voltage and/or earth related Focus on the ignition switch Does it have an aftermarket alarm/immobiliser? -
putting this here for now,
Door trim removal, speaker removal, grab handle etc. (door mechanism and window switches ) i found a better grab handle for the door trim at the wreckers the other week, and needed to figure out how to get the door trim off My car to fit it (already removed at wreckers) -
Hey All, Got a strange one today. Replaced a broken odometer gear in the speedo. Bit fiddly but easy enough to do. However once I hooked my battery back up the fuel pump primed and a clicking sound came out of one of the relays. Inside the cab the Altinator and smart lock lights were on. Key was OUT of the ignition. Put the key in to try to start it and nothing. Put the battery on a charger for a couple of hours. Came back and smart lock light was off but Alt light still on. Ute started ok but the ALT gauge showed no charge. Went for a quick drive and nothing changed, then I went to turn it off and it wouldn't turn off! Even disconnected the neg terminal. Only when i did the pos terminal is stopped. Any ideas? Do I need a Preist to throw holy water over it or something??
-
air shocks were usually a bandaid for towing and sagging springs. quite handy for that. big bore shocks are recommended for any stiffer spring.
ultima are cheapest, i used Pedders red big bore ones (second hand)
koni would be awesome if affordable. -
Seems Air shocks are a bit archaic & out of date. Thinking now of going with Cobra lows with KYB shock absorbers
-
-
Today's Birthdays